![blank screen after entering startx blank screen after entering startx](https://image.slidesharecdn.com/bizsmarts-win8-present-short-130316183512-phpapp02/95/slide-27-1024.jpg)
So, to be more specific, problem occurs in both VGA and DVI-D. Here is the clip from the syslog:Īpr 12 10:26:59 jcave kernel:, SDVOB device VID/DID: 04:AA.03, clock range 25MHz - 165MHz, input 1: Y, input 2: N, output 1: Y, output 2: N > Will you please try the attached debug patch and see whether the issue still > At the moment no, but if you need it I think I can try something. > Do you have an opportunity to try another monitor and see whether it can work?
![blank screen after entering startx blank screen after entering startx](https://4.bp.blogspot.com/-wTVrlH2UC0M/ULfqvvd6p2I/AAAAAAAAANQ/KDpQ_sUPHzY/s1600/Start+screen.png)
It seems that the driver can't configure the SDVO output timing correctly. It is very interesting that there exists the following warning message related with SDVO when using DVI-D. Same beheauviour appears if trying from VGA and from > No, it doesn't take any more inputs from the keyboard and it's not possible to > Is anything displayed on the external monitor if you enters the console mode?
BLANK SCREEN AFTER ENTERING STARTX DRIVERS
> tested both and picture seems to be black and drivers hangs in both scenarions.ĭo you mean that the issue of blank screen still exists even when using VGA connector? > This a desktop configuration so the there is DVI-D and VGA outputs both. > It seems that the external monitor is connected throught DVI-D connector.
BLANK SCREEN AFTER ENTERING STARTX HOW TO
> Shall I try newer version from the driver repository or please tell me how to Please also attach the output of vbios.dump on your box, which can be obtained by using the following command:ġ. Is anything displayed on the external monitor if you enters the console mode?ĭo you have an opportunity to try another monitor and see whether it can work? It seems that the external monitor is connected throught DVI-D connector. > if DRM-i915+KMS is enabled, but that seems to be normal anyway? > remote session from another box and run reboot. > Input from keyboard is not received by the X so only way to reboot is to take a
![blank screen after entering startx blank screen after entering startx](https://www.thewindowsclub.com/wp-content/uploads/2013/08/How-To-Get-Fixed-Layout-For-Start-Screen-In-Windows-8.1-4-600x342.png)
> totally blank except small cursor in left upper corner is shown (not blinking). > Using 2.6.33 and KMS enabled (with i915 driver). Try the debug patch that disable memory self-refresh on 965 desktop platform Try the debug patch that dumps the output pixel clock range of SDVO device Xorg logfile take after boot (forced restart since box hang)Ĭat'd from /sys/devices/pci0000:00/0000:00:02.0/rom Intel_reg_dump run after boot before any X sessions